Integration Relay: Removal

WARNING: This page is about a different variant/trim than selected.

SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (See REMOVAL )
REMOVE RESERVOIR BRACKET (See REMOVAL )
REMOVE NO. 1 RELAY BLOCK COVER
1. Remove the No. 1 relay block cover.
  
  Fig 1: Identifying No. 1 Relay Block Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY
1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and disconnect the engine room junction block assembly.
  
  Fig 2: Removing Engine Room Junction Block Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the 4 connectors.
  
  Fig 3: Locating Engine Room Junction Block Assembly Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002