Air Fuel Ratio Sensor: Installation
- INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
- Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure that SST and the wrench are connected in a straight line.
- Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly RH.
- INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH (See INSTALLATION )
- INSTALL MANIFOLD STAY (See INSTALLATION )
- INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (See INSTALLATION )
- INSTALL CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- INSTALL TAIL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
- FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
- INSPECT FOR EXHAUST GAS LEAK (See INSTALLATION )
- INSPECT AND ADJUST TRANSFER OIL (for 4WD)
HINT:
See TRANSFER OIL
- INSTALL FRONT FLOOR COVER LH (See INSTALLATION )
- INSTALL NO. 2 ENGINE UNDER COVER (See INSTALLATION )
- INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
- INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )
- INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)
- Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure that SST and the wrench are connected in a straight line.
- Connect the air fuel ratio sensor connector and install the clamp.
- Using SST, install the air fuel ratio sensor to the exhaust manifold sub-assembly LH.