LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Highlander Base, 3.5 S, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2GR-FE) - System And Component Testing, Removal, Inspection And Installation >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
    2. Install the crankshaft position sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the crankshaft position sensor connector.
      Fig 1: Locating Crankshaft Position Sensor Bolt
      G04968644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. TEMPORARILY TIGHTEN COMPRESSOR AND MAGNETIC CLUTCH  (See INSTALLATION )
  3. INSTALL COMPRESSOR AND MAGNETIC CLUTCH  (See INSTALLATION )
  4. CONNECT SUCTION HOSE SUB-ASSEMBLY  (See INSTALLATION )
  5. CONNECT DISCHARGE HOSE SUB-ASSEMBLY  (See INSTALLATION )
  6. INSTALL RADIATOR ASSEMBLY AND FAN ASSEMBLY WITH MOTOR  (See INSTALLATION )
  7. INSTALL COOLER CONDENSER ASSEMBLY  (See INSTALLATION )
  8. INSTALL UPPER RADIATOR SUPPORT SUB-ASSEMBLY  (See INSTALLATION )
  9. INSTALL HOOD LOCK ASSEMBLY (w/ Engine Hood Courtesy Switch)  (See INSTALLATION )
  10. INSTALL HOOD LOCK ASSEMBLY (w/o Engine Hood Courtesy Switch)  (See INSTALLATION )
  11. INSTALL RADIATOR GRILLE  (See INSTALLATION )
  12. CONNECT COOLING FAN ECU CONNECTOR  (See INSTALLATION )
  13. CONNECT OIL COOLER HOSE  (See INSTALLATION )
  14. CONNECT NO. 2 RADIATOR HOSE  (See INSTALLATION )
  15. CONNECT NO. 1 RADIATOR HOSE  (See INSTALLATION )
  16. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  17. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  18. INSTALL BATTERY  (See INSTALLATION )
  19. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  20. CHARGE WITH REFRIGERANT  (See REPLACEMENT )
  21. ADD ENGINE COOLANT  (See REPLACEMENT )
  22. INSPECT FOR COOLANT LEAK  (See COOLING SYSTEM )
  23. INSPECT AUTOMATIC TRANSAXLE FLUID 

    HINT:

    See AUTOMATIC TRANSAXLE FLUID

  24. INSPECT FOR OIL LEAK 
  25. WARM UP ENGINE  (See REPLACEMENT )
  26. INSPECT FOR REFRIGERANT LEAK  (See REPLACEMENT )
  27. INSTALL NO. 1 ENGINE UNDER COVER  (See INSTALLATION )
  28. INSTALL ENGINE UNDER COVER ASSEMBLY  (See INSTALLATION )
  29. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals