Heated Oxygen Sensor: Installation
- INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure that SST and the wrench are connected in a straight line.
- Using SST, install the heated oxygen sensor to the front No. 3 exhaust pipe sub-assembly.
- INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
- Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
HINT:
- Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
- Make sure that SST and the wrench are connected in a straight line.
- Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.
- INSTALL FRONT EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- INSTALL FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (See INSTALLATION )
- INSTALL CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- INSTALL TAIL EXHAUST PIPE ASSEMBLY (See INSTALLATION )
- TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
- FULLY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (for 4WD) (See INSTALLATION )
- INSPECT FOR EXHAUST GAS LEAK (See INSTALLATION )
- INSPECT AND ADJUST TRANSFER OIL (for 4WD)
HINT:
See TRANSFER OIL
- INSTALL FRONT FLOOR COVER LH
- Install the 3 clamps, 6 bolts and the front floor cover LH.
- INSTALL NO. 2 ENGINE UNDER COVER (See INSTALLATION )
- INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
- INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )