Throttle Body: Installation

INSTALL THROTTLE BODY
1. Install a new throttle body gasket to the intake air surge tank.
  
  Fig 1: Identifying Throttle Body Gasket On Intake Air Surge Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
  
  Fig 2: Locating Bolts On Throttle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 2 water by-pass hoses.
  
  Fig 3: Locating Water By-Pass Hoses On Throttle Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the throttle body connector and clamp.
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
ADD ENGINE COOLANT (See REPLACEMENT )
INSPECT FOR COOLANT LEAK (See COOLING SYSTEM )
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (See INSTALLATION )

Fig 4: Locating Throttle Body Connector And Clamp
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER (See INSTALLATION )
INSTALL ENGINE UNDER COVER ASSEMBLY (See INSTALLATION )