DTC 01-D5 Absence of Registration Unit; DTC 01-D8 No Response for Connection Check; DTC 01-D9 Last Mode Error; DTC 01-DA No Response Against ON/OFF Command; DTC 01-DB Mode Status Error; DTC 01-DE Slave Reset: Description
DTC DESCRIPTION CHART
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-D5*1, *3 | When either condition below is met:
|
|
| 01-D8*2, *3 | The component shown by the sub-code is (was) disconnected from the system after the engine starts. | |
| 01-D9*1, *3 | The device that had functioned before the engine stopped is (was) disconnected from the system when the engine switch is (was) on (ACC) or on (IG). | |
| 01-DA*3 | When either condition below is met:
|
|
| 01-DB*1, *3 | Dual alarm is detected. | |
| 01-DE*3 | The slave device has been disconnected after the engine starts. | |
| HINT: *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or engine start voltage. *2: If the power connector is disconnected after the engine starts, this code is stored after 180 seconds. *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device. |
||
NOTE:
- Before starting troubleshooting, be sure to clear DTCs to clear codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The multi-display is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.