Inspection Procedure

1. Check for foreign matter on the display.

   OK: The display is clean. 

NG: CLEAN DISPLAY AND RECHECK TOUCH PANEL 

OK: Go to Next Step 

1. Enter the "Display Check" mode and select "Touch Switch Check" (See OPERATION CHECK  ).
2. Touch the display in the area where the switch malfunction occurs.

   OK: A "+" mark appears at the touched position. 

NG: REPLACE MULTI-DISPLAY  (See MULTI-DISPLAY (W/NAVIGATION SYSTEM)  )

Fig 1: Display - Touch Switch Check

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )