Data List / Active Test
- DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / (desired system) / Data List.
- According to the display on the Techstream, read the Data List.
Mirror
DATA LIST (MIRROR)Tester Display Measurement Item/Range Normal Condition Diagnostic Note Driver Side SET Mem SW Driver side seat memory SET switch / ON or OFF ON: Driver side seat memory SET switch on
OFF: Driver side seat memory SET switch off- Driver Side Memory SW 1 Driver side seat memory switch 1 / ON or OFF ON: Driver side seat memory switch 1 on
OFF: Driver side seat memory switch 1 off- Driver Side Memory SW 2 Driver side seat memory switch 2 / ON or OFF ON: Driver side seat memory switch 2 on
OFF: Driver side seat memory switch 2 off- Driver Side Memory SW 3 Driver side seat memory switch 3 / ON or OFF ON: Driver side seat memory switch 3 on
OFF: Driver side seat memory switch 3 off- Driver Seat
DATA LIST (DRIVER SEAT)Tester Display Measurement Item/Range Normal Condition Diagnostic Note Reclining Rear Reclining switch signal (Rearward) / ON or OFF ON: Reclining switch (Rearward) on
OFF: Reclining switch (Rearward) off- Reclining Front Reclining switch signal (Forward)/ON or OFF ON: Reclining switch (Forward) on
OFF: Reclining switch (Forward) off- Front Vertical Down Front vertical switch signal (Downward) / ON or OFF ON: Front vertical switch (Downward) on
OFF: Front vertical switch (Downward) off- Front Vertical Up Front vertical switch signal (Upward) / ON or OFF ON: Front vertical switch (Upward) on
OFF: Front vertical switch (Upward) off- Lifter Switch Down Lifter switch signal (Downward)/ ON or OFF ON: Lifter switch (Downward) on
OFF: Lifter switch (Downward) off- Lifter Switch Up Lifter switch signal (Upward) / ON or OFF ON: Lifter switch (Upward) on
OFF: Lifter switch (Upward) off- Slide Rear Sliding switch signal (Rearward) / ON or OFF ON: Sliding switch (Rearward) on
OFF: Sliding switch (Rearward) off- Slide Front Sliding switch signal (Forward) / ON or OFF ON: Sliding switch (Forward) on
OFF: Sliding switch (Forward) off- SET Switch Seat memory SET switch signal / ON or OFF ON: Seat memory SET switch on
OFF: Seat memory SET switch off- M1 Switch Seat memory switch 1 signal / ON or OFF ON: Seat memory switch 1 on
OFF: Seat memory switch 1 off- M2 Switch Seat memory switch 2 signal / ON or OFF ON: Seat memory switch 2 on
OFF: Seat memory switch 2 off- M3 Switch Seat memory switch 3 signal / ON or OFF ON: Seat memory switch 3 on
OFF: Seat memory switch 3 off- Seat Memory No1 Seat position memorized with seat memory switch 1 / Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Seat Memory No2 Seat position memorized with seat memory switch 2 / Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Seat Memory No3 Seat position memorized with seat memory switch 3 / Mem or Not Mem Mem: Memorized
Not Mem: Not memorized- Ignition Switch Communication state of engine switch signal / ON or OFF ON: Engine switch on (IG) signal received
OFF: Engine switch off signal received- Key Switch Engine switch status (IG) / ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off- Key Code Conf Recognition code is registered / ON or OFF ON: One more recognition codes registered
OFF: No recognition code registered- D-Door Courtesy Door courtesy switch signal / ON or OFF ON: Driver side door open
OFF: Driver side door closed- P Switch Shift lever position P signal / ON or OFF ON: Shift lever in P
OFF: Shift lever not in P- Parking Brake SW Parking brake switch status / ON or OFF ON: Parking brake operated
OFF: Parking brake released- Vehicle Speed Vehicle speed data / Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Actual vehicle speed - Power Voltage Power supply for driver seat ECU / MIN: 0 V, MAX: 19.89 V Within range from 11 V to 14 V - Slide Position Seat sliding position / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Reclining Position Seatback position / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Front Vertical Position Seat front vertical position / MIN: 4096 MAX: 61440 Within range from 4096 to 61440 - Lifter Position Seat lifter position / MIN: 4096 MAX: 61440 Within range from 4096 to 61440 - Slide Pos Mem No1 Seat sliding position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Reclining Pos Mem No1 Seatback position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Front Vertical Pos Mem No1 Front vertical position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Lifter Pos Mem No1 Lifter position memorized with seat memory switch 1 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Slide Pos Mem No2 Seat sliding position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Reclining Pos Mem No2 Seatback position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Front Vertical Pos Mem No2 Front vertical position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Lifter Pos Mem No2 Lifter position memorized with seat memory switch 2 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Slide Pos Mem No3 Seat sliding position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Reclining Pos Mem No3 Seatback position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Front Vertical Pos Mem No3 Front vertical position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 - Lifter Pos Mem No3 Lifter position memorized with seat memory switch 3 / MIN: 4096, MAX: 61440 Within range from 4096 to 61440 -
- ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
- Turn the engine switch off.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Driver Seat / Active Test.
- According to the display on the Techstream, perform the Active Test.
Driver Seat
ACTIVE TEST DETAILTester Display Test Part Control Range Diagnostic Note Seat Reclining Seat reclining operation Front / OFF / Rear - Front Vertical Operation Seat front vertical operation Up / OFF / Down - Lifter Operation Seat lifter operation Up / OFF / Down - Seat Slide Operation Seat sliding operation Front / OFF / Rear - Buzzer Buzzer operation ON / off -