LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Land Cruiser >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Circuit Tests And Service Information >> Power Steering Oil Pressure Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Steering Oil Pressure Switch: Installation

  1. INSTALL POWER STEERING OIL PRESSURE SWITCH 
    1. Install a new O-ring to the oil pressure switch.
    2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.
      NOTE:
      • When reusing the oil pressure switch, inspect the O-ring.
      • If the O-ring has scratches or cuts, replace the oil pressure switch.
    3. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    4. Connect the oil pressure switch connector.
      Fig 1: Locating Power Steering Oil Pressure Switch Connector
      G05628296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL FAN AND GENERATOR V BELT  (See INSTALLATION )
  3. INSTALL AIR CLEANER ASSEMBLY  (See INSTALLATION )
  4. INSTALL AIR CLEANER HOSE ASSEMBLY  (See INSTALLATION )
  5. ADD POWER STEERING FLUID 
  6. BLEED POWER STEERING FLUID  (See ON-VEHICLE INSPECTION )
  7. INSPECT FOR POWER STEERING FLUID LEAK 
  8. INSTALL FRONT FENDER APRON SEAL FRONT RH  (See INSTALLATION )
  9. INSTALL FRONT WHEEL 
  10. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY  (See INSTALLATION )
  12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH  (See INSTALLATION )
  13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH  (See INSTALLATION )
scientia non olet · About LEMON Manuals