Steering Column Assembly: Reassembly

INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
1. Install the ECU with the 2 screws.
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
2. Connect the 2 connectors.
  NOTE: The connectors on both ends of the wire harness between the telescopic motor and ECU are the same shape. When connecting them, connect the connectors of the same color.
  
  Fig 1: Locating Multiplex Tilt And Telescopic ECU Connectors And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING LOCK ACTUATOR ASSEMBLY
1. Temporarily install the steering lock actuator assembly with 2 new tapered-head bolts.
2. Tighten the 2 tapered-head bolts until the bolt heads break off.
  
  Fig 2: Tightening Tapered-Head Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002