LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Matrix Base, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio/Visual >> Audio And Visual System >> Radio Receiver Power Source Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. INSPECT RADIO RECEIVER 
    1. Disconnect the radio receiver connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      RESISTANCE SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      E40-20 (E) - Body ground*1 Always Below 1 Ω
      E1-7 (E) - Body ground*2 Always Below 1 Ω
    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage 

      VOLTAGE SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      E40-1 (B) - E40-20 (E)(1) Always 11 to 14 V
      E1-4 (B) - Ei-7 (E)(2) Always 11 to 14 V
      E40-11 (ACC) - E40-20 (E)(1) Ignition switch ACC 11 to 14 V
      E1-3 (ACC) - E1-7 (E)(2) Ignition switch ACC 11 to 14 V
      (1) for 7 Speakers
      (2) Except for 7 Speakers
      Fig 1: Identifying E40 And E1 Radio Receiver Connectors
      G06035748Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )

scientia non olet · About LEMON Manuals