Transfer Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSFER ASSEMBLY
1. Install the transfer assembly to the transaxle assembly with the 2 bolts and 6 nuts.
  Torque: 69 N*m (700 kgf*cm, 51 ft.*lbf)
  NOTE:
  - Install the transfer assembly to the transaxle assembly horizontally.
  - Do not touch the transfer assembly oil seals during installation.
    
    Fig 1: Locating Transfer Assembly Bolts And Nuts
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AUTOMATIC TRANSAXLE ASSEMBLY (See INSTALLATION )
INSTALL TRANSFER STIFFENER PLATE RH
1. Install the transfer stiffener plate RH with the 4 bolts.
  Torque: 34 N*m (347 kgf*cm, 25 ft.*lbf)
  
  Bolt length:
  
  Bolt A:
  
  45 mm (1.7717 in.)
  
  Bolt B:
  
  30 mm (1.1811 in.)
INSTALL DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT (See INSTALLATION )

Fig 2: Locating Transfer Stiffener Plate RH Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR ENGINE MOUNTING BRACKET (See INSTALLATION )
CONNECT WIRE HARNESS (See INSTALLATION )
INSTALL STARTER ASSEMBLY (See INSTALLATION )
TEMPORARILY TIGHTEN REAR ENGINE MOUNTING INSULATOR (See INSTALLATION )
INSTALL ENGINE ASSEMBLY WITH TRANSAXLE
EM-90 for 2AZ-FE.