Inspection Procedure

HINT:

Read freeze frame data using the Techstream. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2111 or P2112) 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
   5. Read the DTCs.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC P2111 or P2112 is output	A
      DTC P2111 or P2112 and other DTCs are output	B

      HINT:

      If any DTCs other than P2111 or P2112 are output, troubleshoot those DTCs first.

      B: GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART )

      A: Go to next step 

2. INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) 
   1. Check for contamination such as carbon between the throttle valve and the housing. If necessary, clean the throttle body. After cleaning check that the throttle valve moves smoothly.

      OK: Throttle valve is not contaminated with foreign objects and moves smoothly  .

      NG: REPLACE THROTTLE BODY ASSEMBLY  (See REMOVAL )

      OK: Go to next step 

3. CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112) 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Clear DTCs (See DTC CHECK / CLEAR ).
   5. Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
   6. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
   7. Read the DTCs.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is not output	A
      DTC P2111 or P2112 is output	B

      B: REPLACE ECM  (See REMOVAL )

      A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS )