LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Matrix Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System (2AZ-FE)) >> Crankshaft Position Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE ENGINE UNDER COVER RH 
  3. REMOVE V-RIBBED BELT  (See ON-VEHICLE INSPECTION )
  4. REMOVE GENERATOR ASSEMBLY  (See REMOVAL )
  5. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Separate the crankshaft position sensor connector clamp and wire harness.
    3. Remove the bolt and crankshaft position sensor.
    Fig 1: Locating Crankshaft Position Sensor Connector Clamp
    G06007638Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals