DTC P0335 Crankshaft Position Sensor "A" Circuit; DTC P0339 Crankshaft Position Sensor "A" Circuit Intermittent: Description
WARNING: This page is about a different variant/trim than selected.
The crankshaft position sensor system consists of a crankshaft position sensor plate and a pickup coil. The sensor plate has 34 teeth and is installed on the crankshaft. The pickup coil is made of wound copper wire, an iron core and magnet. The sensor plate rotates and, as each tooth passes by the pickup coil, a pulse signal is created. The pickup coil generates 34 signals per engine revolution. Based on these signals, the ECM calculates the crankshaft position and engine RPM. Using these calculations, the fuel injection time and ignition timing are controlled.
DTC DETECTION CONDITION CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0335 | When either of following conditions is met: (1 trip detection logic)
|
|
| P0339 | Following conditions (a), (b) and (c) are met: (1 trip detection logic)
|
|
Reference: Inspection using an oscilloscope.
HINT:
- The correct waveform is as shown.
- G2+ stand for the camshaft position sensor signal, and NE+ stands for the crankshaft position sensor signal.
- A failure of the ground for the shielding of the wiring may result in noisy waveforms.
ECM TERMINAL REFERENCE
| ECM Terminal Name | CH1: Between G2+ and G2- CH2: Between NE+ and NE- |
|---|---|
| Tester Range | 5 V/DIV., 20 msec./DIV. |
| Condition | Idling |