Confirmation Driving Pattern

HINT:

Performing this confirmation pattern will activate the mass air flow performance monitor.

Fig 1: Driving Pattern Of Vehicle Speed And Time

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs (See DTC CHECK / CLEAR ).
5. Start the engine, and warm it up until the engine coolant temperature reaches 70°C (158°F) or higher [A].
6. Drive the vehicle at approximately 62 mph (100 km/h) for 20 seconds or more [B].
7. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes; then check if any DTCs (any pending DTCs) are set.