Confirmation Driving Pattern

WARNING: This page is about a different variant/trim than selected.

HINT:

Performing this confirmation pattern will activate the catalyst monitor. This is very useful for verifying the completion of a repair.

Fig 1: Driving Pattern Of Vehicle Speed And Time

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear the DTCs (if set) (See DTC CHECK / CLEAR ).
Enter the following menus: Powertrain / Engine and ECT / Monitor.
Check that Catalyst / Status 2 is Incomplete.
Start the engine and warm it up.
Drive the vehicle at between 40 mph and 70 mph (64 km/h and 113 km/h) for at least 10 minutes.
Those items will change to Complete as Catalyst monitor operates.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if any DTCs (any pending DTCs) are set.

HINT:

If Catalyst does not change to Complete, and any pending DTCs fail to set, extend the driving time.