Inspection Procedure
NOTE:
Be sure to read Description before performing the following procedure.
- CHECK FOR DTC OF OTHER COMPONENTS
- Check if the component shown by the sub-code is displayed in the check result of the other components.
- Check if "01-DC" is output for the other components.
- If "01-DC" is output for any other components, check if the same physical address is displayed.
Result
RESULT REFERENCEResult Proceed to "01-DC" is output and the same physical address is displayed A "01-DC" is not output or the same physical address is not displayed B HINT:
For the list of the components shown by sub-codes, refer to the table in step 2.
B: Go to step 4
A: Go to Next Step
- Check if the component shown by the sub-code is displayed in the check result of the other components.
- IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE
- Enter diagnostic mode.
- Press the preset switch "3" to change the mode to "Detailed Information Mode".
- Identify the component which has stored this code.
Component Table
COMPONENT REFERENCE CHARTComponent Physical Address Stereo component amplifier 440 Radio receiver 190 HINT:
- "P440" set by the stereo component amplifier is shown in the preceding illustration as an example.
- For details of the DTC display, refer to DTC CHECK / CLEAR .
- CHECK COMPONENT WHICH HAS STORED THIS CODE
- Select the component which has stored this code.
Component Table
COMPONENT REFERENCE CHARTComponent Proceed to Stereo component amplifier Stereo component amplifier communication error (See STEREO COMPONENT AMPLIFIER COMMUNICATION ERROR ) Radio receiver Radio receiver communication error (See RADIO RECEIVER COMMUNICATION ERROR ) NEXT: END
- Select the component which has stored this code.
- CLEAR DTC
- Clear the DTCs (See DTC CHECK / CLEAR
).
HINT:
If "01 -DC" is output for only one component, this may not indicate a malfunction.
- Clear the DTCs (See DTC CHECK / CLEAR
).
- RECHECK FOR DTC
- Recheck for DTCs and check if the same trouble occurs again.
OK:
Malfunction disappears .
NG: Go to step 6
OK: END
- Recheck for DTCs and check if the same trouble occurs again.
- CHECK COMPONENT WHICH HAS STORED THIS CODE
- Select the component which has stored this code.
Component Table
COMPONENT REFERENCE CHARTComponent Proceed to Stereo component amplifier Stereo component amplifier communication error (See STEREO COMPONENT AMPLIFIER COMMUNICATION ERROR ) Radio receiver Radio receiver communication error (See RADIO RECEIVER COMMUNICATION ERROR )
- Select the component which has stored this code.