How To Proceed With Troubleshooting

HINT:

Use the following procedure to troubleshoot the wiper and washer system.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

3. PROBLEM SYMPTOM CONFIRMATION 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   B: Go to step   5 

   A: Go to next step 

4. SYMPTOM SIMULATION 

   Refer to ELECTRONIC CIRCUIT INSPECTION PROCEDURE .

5. PROBLEM SYMPTOMS TABLE 

   Refer to PROBLEM SYMPTOMS TABLE .

6. CIRCUIT INSPECTION 
7. IDENTIFICATION OF PROBLEM 
8. REPAIR OR REPLACE 
9. CONFIRMATION TEST