LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Matrix Base, Standard >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Door Lock >> Unlock Warning Switch >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Unlock Warning Switch: Installation

  1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY 
    1. Attach the 2 claws to install the unlock warning switch onto the steering column upper bracket.

      HINT:

      Slide the unlock warning switch in the direction shown by the arrow in the illustration to install it.

  2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY  (See REASSEMBLY )
  3. INSTALL SOLENOID WIRE (for Automatic Transaxle)  (See REASSEMBLY )
  4. INSTALL KEY INTERLOCK SOLENOID (for Automatic Transaxle)  (See REASSEMBLY )
    Fig 1: Identifying Unlock Warning Switch Assembly And Claws
    G05389793Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transaxle)  (See REASSEMBLY )
  6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle)  (See REASSEMBLY )
  7. INSPECT STEERING LOCK OPERATION  (See INSPECTION )
  8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY  (See INSTALLATION )
  9. INSTALL STEERING POST ASSEMBLY  (See INSTALLATION )
  10. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD 
  11. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 2WD)  (See INSTALLATION )
  12. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY (for 4WD)  (See INSTALLATION )
  13. INSTALL STOP LIGHT SWITCH ASSEMBLY  (See INSPECTION )
  14. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY  (See INSTALLATION )
  15. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT  (See INSTALLATION )
  16. INSTALL COLUMN HOLE COVER SILENCER SHEET  (See INSTALLATION )
  17. INSTALL TRANSPONDER KEY AMPLIFIER (w/ Engine Immobilizer System)  (See INSTALLATION )
  18. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  19. INSTALL UPPER STEERING COLUMN COVER  (See INSTALLATION )
  20. REMOVE LOWER STEERING COLUMN COVER  (See INSTALLATION )
  21. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  22. INSTALL NO. 1 SWITCH HOLE BASE  (See INSTALLATION )
  23. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL  (See INSTALLATION )
  24. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL (for Automatic Transaxle)  (See INSTALLATION )
  25. INSTALL FRONT NO. 1 CONSOLE BOX INSERT  (See INSTALLATION )
  26. INSTALL FRONT NO. 2 CONSOLE BOX INSERT  (See INSTALLATION )
  27. INSTALL FRONT CONSOLE BOX ASSEMBLY 

    HINT:

    Refer to the instructions for Installation of the front console box (See INSTALLATION ).

  28. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY 

    HINT:

    Refer to the instructions for Installation of the upper instrument panel (See INSTALLATION ).

  29. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD 
  30. ADJUST SPIRAL CABLE  (See INSTALLATION )
  31. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  32. INSTALL STEERING PAD  (See INSTALLATION )
  33. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  34. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  35. INSPECT STEERING WHEEL CENTER POINT 
  36. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  37. INSPECT STEERING PAD  (See INSTALLATION )
  38. CALIBRATE TORQUE SENSOR ZERO POINT 

    HINT:

    (See CALIBRATION ).

  39. INSPECT SRS WARNING LIGHT 

    HINT:

    (See DIAGNOSIS SYSTEM ).

scientia non olet · About LEMON Manuals