Front Axle Hub Bolt: Replacement

HINT:

• Use the same procedure for the RH side and LH side.
• The procedure listed below is for the LH side.

1. REMOVE FRONT WHEEL 
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY 
   1. Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.
      NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
3. REMOVE FRONT DISC  (See REMOVAL )
   Fig 1: Locating Front Disc Brake Caliper Assembly Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. SEPARATE FRONT DISC BRAKE DUST COVER 
   1. Remove the 3 bolts and separate the front disc brake dust cover.
      Fig 2: Locating Front Disc Brake Dust Cover Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. REMOVE FRONT AXLE HUB BOLT 
   1. Temporarily install the 2 nuts and 2 washers to the front axle hub bolt as shown in the illustration.

      Recommended service nut: 

      Thread diameter: 

      12.0 mm (0.472 in.) 

      Thread pitch: 

      1.5 mm (0.0591 in.) 

   2. Using SST and a brass bar or an equivalent tool to hold the front axle, remove the front axle hub bolt.

      SST 09611-12010 

      Fig 3: Removing Front Axle Hub Bolt Using SST 09611-12010

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. INSTALL FRONT AXLE HUB BOLT 
   1. Install a washer and nut to a new front axle hub bolt as shown in the illustration.

      Recommended service nut: 

      Thread diameter: 

      12.0 mm (0.472 in.) 

      Thread pitch: 

      1.5 mm (0.0591 in.) 

      HINT:

      Recommended thickness of the washer is 5 mm (0.197 in.) or more.

   2. Using a brass bar to hold the front axle, install the hub bolt by tightening the nut.
      Fig 4: Installing Hub Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. INSTALL FRONT DISC BRAKE DUST COVER 
   1. Install the front disc brake dust cover with the 3 bolts.

      Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf) 

8. INSTALL FRONT DISC  (See INSTALLATION )
   Fig 5: Locating Front Disc Brake Dust Cover Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
9. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY 
   1. Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

      Torque: 107 N*m (1089 kgf*cm, 79 ft.*lbf) 

      NOTE: Do not twist the brake hose when installing the front disc brake caliper assembly.
10. INSTALL FRONT WHEEL 

    Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

    Fig 6: Locating Front Disc Brake Caliper Assembly Bolts

    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002