Installation (To 12/2010): Installation

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the 2 connectors to the front passenger airbag assembly.
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
2. Install the clip.
INSTALL NO. 3 HEATER TO REGISTER DUCT . Refer to REASSEMBLY - Step 14
INSTALL NO. 2 SIDE DEFROSTER NOZZLE DUCT . Refer to REASSEMBLY - Step 12
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY . Refer to INSTALLATION - Step 1
CONNECT INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the connector.
  
  Fig 1: Connecting Airbag Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE:
  When handling the airbag connector, take care not to damage the airbag wire harness.
INSTALL TIRE PRESSURE MONITOR ECU
Refer to INSTALLATION - Step 3
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM