April 5, 2026: LEMON Manuals is launched! Read the announcement.

Section 5 (Charging System (2AZ-FE)): Generator: Removal

WARNING: This page is about a different variant/trim than selected.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT (See REMOVAL )
REMOVE GENERATOR ASSEMBLY
1. Remove the terminal cap.
2. Remove the nut and disconnect the wire harness from terminal B.
3. Disconnect the generator connector and 2 harness clamps.
  
  Fig 1: Identifying Terminal Cap, Nut, Generator Connector And Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 2 bolts and generator assembly.
  
  Fig 2: Locating Generator Assembly Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the bolt and wire harness clamp bracket.
  
  Fig 3: Locating Wire Harness Clamp Bracket Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002