Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
M/T Models, Case 1
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | P0102 - P0103 (Mass air flow meter) P0115 - P0118 (Engine coolant temperature sensor) P0125 (Insufficient engine coolant temperature for Closed Loop) |
| Engine coolant temperature | 70°C (158°F) or more |
| Engine speed | 2000 to 5000 rpm |
| Engine load | 31.9 % or more |
| Fuel-cut at high engine speed | Not executing |
M/T Models, Case 2
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | P0102 - P0103 (Mass air flow meter) P0115 - P0118 (Engine coolant temperature sensor) P0125 (Insufficient engine coolant temperature for Closed Loop) |
| Idle | ON |
| Fuel-cut | ON |
A/T Models
TYPICAL ENABLING CONDITIONS
| Monitor runs whenever following DTCs are not present | None |
| Time after ignition switch OFF to ON | 3 seconds or more |
| Battery voltage | 8 V or more |
| Ignition switch | ON |
| Starter | OFF |