Seat Position Sensor: Installation

1. Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
   Fig 1: Installing Seat Position Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 1.3 mm (0.0512 in.) feeler gauge, set the seat position sensor.
   NOTE:

   • If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.
   • When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
   Fig 2: Setting Seat Position Sensor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   HINT:

   Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 2.0 mm (0.0236 to 0.0787 in.).

3. Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with the seat slide position sensor protector.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

4. Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 2.0 mm (0.0236 to 0.0787 in.).
5. Connect the connector.
   NOTE: When connecting the airbag connector, take care not to damage the airbag wire harness.
6. Check that there is no looseness in the installation parts of the seat position sensor.

Fig 3: Locating Screw And Seat Position Sensor

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for 2WD: (See INSTALLATION )

for 4WD: (See INSTALLATION )

1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).