Inspection Procedure

HINT:

After the inspection is completed, clear the DTCs.

1. CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE) 
   1. Enter the "Navigation Check" mode (Vehicle Sensors) (See OPERATION CHECK  ).
   2. While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are almost equal.
      Fig 1: Locating SPD Reading

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: The readings are almost equal  .

      NG: Go to step   2 

      OK: REPLACE NAVIGATION RECEIVER ASSEMBLY  (See REMOVAL  )

2. PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

   Refer to "Speed signal does not change in the navigation check mode" in Problem Symptoms Table (See PROBLEM SYMPTOMS TABLE  ).