April 5, 2026: LEMON Manuals is launched! Read the announcement.

Automatic Transaxle System: Initialization

WARNING: This page is about a different variant/trim than selected.

RESET MEMORY
NOTE:
- Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM.
- RESET MEMORY can be performed only with the Techstream.
HINT:

The ECM learns various conditions and controls the automatic transaxle assembly and engine assembly according to those characteristics. Therefore, when the automatic transaxle assembly, engine assembly, or ECM has been replaced, it is necessary to reset the memory so that the ECM can re-learn.

Reset procedure is as follows.
1. Turn the ignition switch off.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch to ON and Techstream on.
4. Enter the following menu: Powertrain / Engine and ECT / Utility / Reset Memory. Then, press "Next".
  CAUTION: After performing RESET MEMORY, be sure to perform the ROAD TEST (See ROAD TEST ) described earlier.
  
  HINT:
  
  The ECM learns when the ROAD TEST is performed.