LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Matrix S, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System (2ZR-FE)) >> Accelerator Pedal >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ACCELERATOR PEDAL 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON and turn the Techstream on.
    3. Enter the following menus: Powertrain / Engine and ECT / Data List / Accelerator Position No. 1, Accelerator Position No. 2.
    4. Read the values displayed on the Techstream.

      Accelerator Position No. 1 Standard Voltage 

      SPECIFIED CONDITION CHART

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is fully depressed 2.6 to 4.5 V

      Accelerator Position No. 2 Standard Voltage 

      SPECIFIED CONDITION CHART

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal is fully depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal, wire harness and ECM.

scientia non olet · About LEMON Manuals