DTC P0115 Engine Coolant Temperature Circuit Malfunction; DTC P0117 Engine Coolant Temperature Circuit Low Input; DTC P0118 Engine Coolant Temperature Circuit High Input: Description
WARNING: This page is about a different variant/trim than selected.
A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor.
The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor.
HINT:
When any of DTCs P0115, P0117 and P0118 are set, the ECM enters fail-safe mode. During fail-safe mode, the engine coolant temperature is estimated to be 80°C (176°F) by the ECM. Fail-safe mode continues until a pass condition is detected.
DTC DETECTION CONDITION CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| P0115 | Open or short in Engine Coolant Temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0117 | Short in Engine Coolant Temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
| P0118 | Open in Engine Coolant Temperature sensor circuit for 0.5 seconds (1 trip detection logic) |
|
HINT:
When any of these DTCs are set, check the engine coolant temperature by entering the following menus:
Powertrain / Engine and ECT / Data List / Coolant Temp.
MALFUNCTION CHART
| Temperature Displayed | Malfunction |
|---|---|
| -40°C (-40°F) | Open circuit |
| 140°C (284°F) or higher | Short circuit |