Valve Body Assembly: Installation

INSTALL MANUAL VALVE
1. Install the manual valve to the valve body.
  
  Fig 1: Locating Shift Solenoid Valve SLT With Mounting Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the spring and check ball body.
  
  Fig 2: Identifying Check Ball Body And Spring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Align the groove of the manual valve with the pin of lever.
3. Install the 17 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Fig 3: Identifying Transmission Valve Body Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Push the valve body against the accumulator piston spring and the check ball body to install it.
  - Temporarily tighten the bolts marked * in the illustration first because they are positioning bolts.
  HINT:
  
  Each bolt length is indicated below.
  
  Bolt length:
  
  Bolt A:
  
  25 mm (0.984 in.)
  
  Bolt B:
  
  41 mm (1.61 in.)
  
  Bolt C:
  
  45 mm (1.77 in.)
INSTALL TRANSMISSION WIRE
1. Coat the O-ring of the temperature sensor with ATF WS.
2. Install the ATF temperature sensor with the lock plate and bolt.
  Torque: 6.6 N*m (67 kgf*cm, 58 in.*lbf)
3. Connect the transmission wire to the 5 shift solenoid valve connectors.
Fig 4: Identifying Lock Plate
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
1. Coat a new O-ring with ATF WS.
2. Install the O-ring to the oil strainer.
  
  Fig 5: Locating Oil Strainer O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the oil strainer with the 3 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE UNDER COVER LH
ADD AUTOMATIC TRANSAXLE FLUID
INSPECT TRANSAXLE FLUID LEVEL (See AUTOMATIC TRANSAXLE FLUID )

Fig 6: Locating Oil Strainer Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002