Inspection Procedure

CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - BATTERY, BODY GROUND)

Measure the resistance according to the value(s) in the table below.

Standard Resistance

STANDARD RESISTANCE REFERENCE CHART

Tester Connection	Condition	Specified Condition
E1-7 (E) - Body ground	Always	Below 1 Ω

Measure the voltage according to the value(s) in the table below.

Standard Voltage

STANDARD VOLTAGE REFERENCE CHART

Tester Connection	Condition	Specified Condition
E1-4 (B) - E1-7 (E)	Always	11 to 14 V
E1-3 (ACC) - E1-7 (E)	Ignition switch ACC	11 to 14 V

Fig 1: Identifying E1 Navigation Receiver Assembly Connector

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See PROBLEM SYMPTOMS TABLE )