Inspection Procedure

1. Remove the stop light switch.
2. Measure the resistance of the switch.

   Standard Resistance 

   Tester Connection	Switch Condition	Specified Condition
   1 - 2	Switch pin not pushed	Below 1 Ω
   3 - 4	Switch pin not pushed	10 kΩ or higher
   1 - 2	Switch pin pushed	10 kΩ or higher
   3 - 4	Switch pin pushed	Below 1 Ω

1. Clear the DTC (see DTC CHECK / CLEAR ).
2. Check for DTC (see DTC CHECK / CLEAR ).

   OK : DTC is not output. 

NG : REPLACE HYBRID VEHICLE CONTROL ECU 

OK : END