Inspection Procedure

HINT:

Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. READ OUTPUT DTC (DTC P0604) 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Clear DTC (See DTC CHECK / CLEAR ).
   5. Turn the ignition switch off and turn the Techstream off.
   6. Disconnect the Techstream.
   7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
   8. Connect the cable to the negative (-) battery terminal.
   9. Connect the Techstream to the DLC3.
   10. Turn the ignition switch to ON.
   11. Turn the Techstream on.
   12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
   13. Read DTCs.

       Result 

       RESULT CHART
       
       

       Result	Proceed to
       No output	A
       P0604	B

       B: REPLACE ECM  (See REMOVAL )

       A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS )