LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Testing & Diagnosis >> Engine Control System (2AR-FE) - Diagnostic Codes (3 Of 4) >> DTC P060D Internal Control Module Accelerator Pedal Position Performance >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

  1. READ OUTPUT DTC (DTC P060D) 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Clear DTC (See DTC CHECK / CLEAR ).
    5. Turn the ignition switch off and turn the Techstream off.
    6. Disconnect the Techstream.
    7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    8. Connect the cable to the negative (-) battery terminal.
    9. Connect the Techstream to the DLC3.
    10. Turn the ignition switch to ON.
    11. Turn the Techstream on.
    12. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    13. Read DTCs.

      Result 

      RESULT CHART

      Result Proceed to
      No output A
      P060D B

      B: REPLACE ECM  (See DTC CHECK / CLEAR )

      A: CHECK FOR INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS )

scientia non olet · About LEMON Manuals