Inspection Procedure

NOTE: Be sure to read DESCRIPTION before performing the following procedures.

CHECK FOR DTC OF OTHER COMPONENTS

Check if the component shown by sub-code is displayed in the check result of the other components.
1. Check if "01-DC" is output for the other components.
2. If "01-DC" is output for any other components, check if the same physical address is displayed.

Result

RESULT REFERENCE

Result	Proceed to
"01-DC" is output and the same physical address is displayed	A
"01-DC" is not output or the same physical address is not displayed	B
HINT: For the list of the components shown by sub-codes, refer to the table in the next step.

Result

Proceed to

"01-DC" is output and the same physical address is displayed

"01-DC" is not output or the same physical address is not displayed

HINT:

For the list of the components shown by sub-codes, refer to the table in the next step.

B: Go to step 4

A: Go to next step

IDENTIFY THE COMPONENT WHICH HAS STORED THIS CODE

Enter the diagnostic mode.

Fig 1: Identifying Diagnostic Mode
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Press the preset switch "2" to change to "Detailed Information Mode".
Identify the component which has stored this code.

Component Table:

COMPONENT REFERENCE CHART

Component	Physical address
Stereo component amplifier	440
Radio receiver	190
HINT: "440 (Stereo component amplifier)" is the component which has stored this code in the example shown in the illustration. For details of the DTC display, refer to the "DTC CHECK/CLEAR " (See ).

Component

Physical address

Stereo component amplifier

440

Radio receiver

190

HINT:

"440 (Stereo component amplifier)" is the component which has stored this code in the example shown in the illustration.
For details of the DTC display, refer to the "DTC CHECK/CLEAR " (See ).

CHECK COMPONENT WHICH HAS STORED THIS CODE

Component Table:

COMPONENT REFERENCE CHART

Component	Proceed to
Stereo component amplifier	Stereo component amplifier communication error (See STEREO COMPONENT AMPLIFIER COMMUNICATION ERROR )
Radio receiver	Radio receiver communication error (See RADIO RECEIVER COMMUNICATION ERROR )

NEXT: END

CLEAR DTC
1. Clear the DTC (See DTC CHECK / CLEAR ).
  HINT:
  
  If "01-DC" is output for only one component, this may not indicate a malfunction.
RECHECK DTC
1. Recheck the DTC and check if the same trouble code occurs again.
  OK:
  
  Malfunction disappears.
NG: Go to step 3

OK: END