Inspection Procedure
- CHECK DTC (DTC B2325)
- Connect Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester on.
- Clear the DTCs.
- Recheck DTCs.
Result
RESULT CHARTDisplay (DTC output) Proceed To B2325 A Other DTCs B No DTC output C B: GO TO DTC CHART
C: SYSTEM IS NORMAL
A: GO TO NEXT STEP
- READ VALUE USING TECHSTREAM (Main body ECU)
- Connect Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester ON.
- Read the indication displayed on the tester.
Main body
DATA LISTTester Display Measurement Item/Range Normal Condition Diagnostic Note Communication D-Door Motor Connection status between power window regulator motor and main body ECU / OK or Stop OK: Connection
Stop: No connection- OK:
OK is displayed on Techstream screen.
OK: REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)
NG: GO TO NEXT STEP
- RECHECK DTC (DTC B2325)
- Connect Techstream to the DLC3.
- Turn the ignition switch ON and turn the tester on.
- Clear the DTCs.
- Read DTCs.
Result
RESULT CHARTDisplay (DTC output) Proceed To B2325 A No DTC output B B: SYSTEM IS NORMAL
A: REPLACE INSTRUMENT PANEL JUNCTION BLOCK (MAIN BODY ECU)