LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2AR-FE) - Service Information & Circuit Tests >> Accelerator Pedal Rod >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine and ECT / Data List / ETCS / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
    5. Read the value displayed on the Techstream.

      Standard Voltage: 

      Accel Sensor Out No. 1 

      SPECIFIED CONDITION CHART

      Condition Specified Condition
      Accelerator pedal is released 0.5 to 1.1 V
      Accelerator pedal is depressed 2.6 to 4.5 V

      Standard Voltage: 

      Accel Sensor Out No. 2 

      SPECIFIED CONDITION CHART

      Condition Specified Condition
      Accelerator pedal is released 1.2 to 2.0 V
      Accelerator pedal Is depressed 3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

scientia non olet · About LEMON Manuals