Crankshaft Position Sensor: Installation

INSTALL CRANKSHAFT POSITION SENSOR
1. Apply a light coat of engine oil to the O-ring of the sensor.
  NOTE: Make sure that the O-ring is not cracked or jammed when installing the sensor.
  
  Fig 1: Locating Bolt And Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply adhesive to 2 or 3 threads of the bolt.
  Adhesive:
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent.
3. Install the sensor with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
4. Connect the sensor connector.
INSPECT FOR OIL LEAK

Fig 2: Applying Adhesive To 2 Or 3 Threads Of Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR ENGINE UNDER COVER RH (See CAMSHAFT )