Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)

Disconnect the E62 radio receiver connector and L13 stereo component amplifier connector.
Measure the resistance according to the value(s) in the table below.

Standard resistance

STANDARD RESISTANCE SPECIFICATIONS

Tester Connection	Condition	Specified Condition
E62-11 (IVO+) - L13-15 (INT+)	Always	Below 1 Ω
E62-12 (IVO-) - L13-14 (INT-)	Always	Below 1 Ω
E62-11 (IVO+) - Body ground	Always	10 kΩ or higher
E62-12 (IVO-) - Body ground	Always	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

Fig 1: Identifying E62 Radio Receiver Connector And L13 Stereo Component Amplifier Connector

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE