LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 139 (Audio System & Visual System) >> Audio And Visual System >> Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK WIRE HARNESS (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) 
    1. Disconnect the E62 receiver connector.
    2. Disconnect the L13 amplifier connector.
    3. Measure the resistance of the wire harness side connectors.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATIONS

      Tester Connection Specified Condition
      E62-8 (R+) - L13-5 (R+) Below 1 Ω
      E62-18 (R-) - L13-4 (R-) Below 1 Ω
      E62-9 (L+) - L13-3 (L+) Below 1 Ω
      E62-19 (L-) - L13-2 (L-) Below 1 Ω
      E62-10 (SLD) - L13-6 (SLD) Below 1 Ω
      E62-8 (R+) - Body ground 10 kΩ or higher
      E62-18 (R-) - Body ground 10 kΩ or higher
      E62-9 (L+) - Body ground 10 kΩ or higher
      E62-19 (L-) - Body ground 10 kΩ or higher
      E62-10 (SLD) - Body ground 10 kΩ or higher

      NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

      Fig 1: Identifying E62 And L13 Connector Terminals
      G05184788Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE  

scientia non olet · About LEMON Manuals