Stereo Component Speaker: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL REAR STEREO COMPONENT SPEAKER ASSEMBLY
1. Using an air riveter or hand riveter, install the speaker with 4 new rivets.
  
  Fig 1: Installing Speaker With Rivets
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  NOTE:
  - Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
    
    Fig 2: Precaution For Prying Rivet With Riveter
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Confirm that the rivets are seated properly against the speaker.
    Do not tilt the riveter when installing the rivet to the speaker.
    
    Do not leave any space between the rivet head and speaker.
    
    Fig 3: Identifying Rivets Installation
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.
2. Connect the connector.
INSTALL BACK DOOR TRIM BOARD (see REASSEMBLY )
INSTALL BACK DOOR SIDE GARNISH RH (see REASSEMBLY )
INSTALL BACK DOOR SIDE GARNISH LH (see REASSEMBLY )
INSTALL BACK DOOR CENTER GARNISH (see REASSEMBLY )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 4: Identifying Rivets Installation
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002