Inspection Procedure
WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DISPLAY
- Check the display (at a place with a fine view, is GPS mark displayed or not?).
- NG: Go to step 7
- OK: GO TO NEXT STEP
- CHECK AREA
- Check the area (does the trouble occur in a specific area or not?).
- OK: NORMAL (IF VEHICLE IS POSITIONED IN PLACE WHERE IT IS DIFFICULT TO BE IDENTIFIED, CURRENT VEHICLE POSITION MAY BE INCORRECTLY DISPLAYED)
- NG: GO TO NEXT STEP
- CHECK SETTING
- CHECK FOR DTC
- Check for DTC (is "58-43" displayed in the unit check mode of the navigation ECU?) (see DTC CHECK/CLEAR
).
OK: No DTC is output.
- NG: TROUBLESHOOT FOR EACH DIAGNOSIS
- OK: GO TO NEXT STEP
- Check for DTC (is "58-43" displayed in the unit check mode of the navigation ECU?) (see DTC CHECK/CLEAR
).
- CHECK VEHICLE SENSOR (NAVIGATION CHECK MODE)
- Enter the Navigation Check Mode (Vehicle Sensors) (see DTC CHECK/CLEAR ).
- Check the speed (SPD).
- NG: REPAIR OR REPLACE SPEED SENSOR WIRE HARNESS
- OK: GO TO NEXT STEP
- RECURRENCE TEST (CONFIRM PHENOMENON) (CORRECT CURRENT POSITION AND DRIVE VEHICLE FOR A WHILE WITH GPS MARK DISPLAYED)
- OK: NORMAL
- NG: REPLACE NAVIGATION ECU
- CHECK GPS ANTENNA
- Check if the harness is caught or sharply bent or not.
- NG: GPS ANTENNA IS SURELY CONNECTED
- OK: GO TO NEXT STEP
- CHECK OPTION COMPONENT
- Check if the sun shade film, and other optional components are installed.
OK: Optional component(s) installed.
HINT:
Some optional components receive radio signals.
- OK: REMOVE OR CHANGE POSITION OF OPTIONAL COMPONENT (IF THIS HAPPENS, GPS RECEPTION MAY BE AFFECTED)
- NG: GO TO NEXT STEP
- Check if the sun shade film, and other optional components are installed.
- CHECK FOR DTC
- Check for DTC (is "80-40" or "80-41" displayed in the unit check mode of the navigation ECU?) (see DTC CHECK/CLEAR
).
OK: No DTC(s) is output.
- NG: TROUBLESHOOT FOR EACH DIAGNOSIS
- OK: REPLACE GPS ANTENNA (IF THE TROUBLE STILL OCCURS, REPLACE NAVIGATION ECU)
- Check for DTC (is "80-40" or "80-41" displayed in the unit check mode of the navigation ECU?) (see DTC CHECK/CLEAR
).