LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Control System (2GR-FE) - Component And System Testing, Removal, Inspection & Installation) >> Crankshaft Position Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CRANKSHAFT POSITION SENSOR 
    1. Apply a coat of engine oil to an O-ring of the sensor.
    2. Install the sensor with the bolt.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    3. Connect the sensor connector.
  2. CONNECT COMPRESSOR WITH PULLEY ASSEMBLY 
    1. Connect the compressor with pulley (See INSTALLATION ).
      Fig 1: Locating Crankshaft Position Sensor Bolt
      G05184269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals