Inspection Procedure

HINT:

When the engine switch is off, the main body ECU may occasionally go into a non-active state called sleep mode. Therefore, before proceeding with the inspection, it is necessary to perform the following steps to wake up the ECU:

With the engine switch off, open the driver door. Then (with the engine switch still off) open and close any door several times at 1.5 second intervals.

1. CHECK FOR DTC OUTPUT (B2785) 
   1. Check for DTCs (See DTC CHECK/CLEAR  ).

      OK: DTC B2781 is output, but DTC B2785 is not output. 

      NG: REFER TO B2785  (See )

      OK: REPLACE STEERING LOCK ACTUATOR ASSEMBLY (STEERING LOCK ECU)  (See REMOVAL  )