LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 2.5 F, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (2GR-FE) - Component And System Testing, Removal, Inspection & Installation) >> Crankshaft Position Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT COMPRESSOR WITH PULLEY ASSEMBLY 
    1. Disconnect the compressor with pulley (See REMOVAL ).
  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
      Fig 1: Locating Crankshaft Position Sensor Bolt
      G05184269Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals