LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> RAV4 Base, 3.5 K, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (2GR-FE) - Component And System Testing, Removal, Inspection & Installation >> Accelerator Pedal Rod >> On-Vehicle Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection

  1. CHECK ACCELERATOR PEDAL ROD 
    1. Check the voltage.
      1. Connect the Techstream to the DLC3.
      2. Turn the ignition switch to ON.
      3. Turn the Techstream ON.
      4. Enter the following menus: Powertrain / Engine and ECT / Data List.
      5. Operate the accelerator pedal, and then check that the Accel Sensor Out No. 1 and Accel Sensor Out No. 2 values are within the specifications.

        Standard voltage: 

        Accel Sensor Out No. 1 

        VOLTAGE SPECIFICATION

        Accelerator Pedal Condition Specified Condition
        Released 0.5 to 1.1 V
        Depressed 2.6 to 4.5 V

        Accel Sensor Out No. 2 

        VOLTAGE SPECIFICATION

        Accelerator Pedal Condition Specified Condition
        Released 1.2 to 2.0 V
        Depressed 3.4 to 5.0 V

        If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.

scientia non olet · About LEMON Manuals