LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Sienna LE, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - System & Component Testing, On-Vehicle Inspection, Removal, Inspection & Installation >> Engine Coolant Temperature Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Coolant Temperature Sensor: Installation

  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install the engine coolant temperature sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

      Fig 1: Locating Engine Coolant Temperature Sensor
      G05136409Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Connect the engine coolant temperature sensor connector.
  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION  )
  4. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. ADD ENGINE COOLANT  (See REPLACEMENT )
  7. INSPECT FOR ENGINE COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  8. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
scientia non olet · About LEMON Manuals