LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Sienna LE, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Column Assembly >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Column Assembly: Removal

  1. PRECAUTION 

    HINT:

    See PRECAUTION

  2. DISCONNECT BATTERY NEGATIVE TERMINAL 

    Wait for 90 seconds after disconnecting the battery terminal to prevent the airbag working.

  3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 
  4. REMOVE STEERING WHEEL COVER LOWER NO.2  (See REMOVAL )
  5. REMOVE STEERING WHEEL COVER LOWER NO.3  (See REMOVAL )
  6. REMOVE HORN BUTTON ASSEMBLY  (See REMOVAL )
  7. REMOVE STEERING WHEEL ASSEMBLY 
    1. Remove the steering wheel assembly set nut.
    2. Put matchmarks on the steering wheel assembly and main shaft assembly.
    3. Using SST, remove the steering wheel assembly.

      SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021) 

      Fig 1: Removing Steering Wheel Assembly
      G05140345Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE STEERING COLUMN COVER 
    1. Remove the 2 screws and steering column cover.
    Fig 2: Removing Screws And Steering Column Cover
    G05140346Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE SPIRAL CABLE SUB-ASSEMBLY  (See REMOVAL )
  10. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY  (See REMOVAL )
  11. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY  (See REMOVAL )
  12. REMOVE FRONT DOOR SCUFF PLATE LH 
  13. REMOVE COWL SIDE TRIM BOARD LH 
  14. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH  (See REMOVAL )
  15. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT SUB-ASSEMBLY NO.1  (See REMOVAL )
  16. REMOVE HEATER TO FOOT DUCT NO.3 
    1. Disengage the 3 claws and remove the sir duct No. 3.
  17. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY 
    1. Loosen the bolt.
      Fig 3: Loosening Bolt
      G05140347Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Release the 3 clips and separate the dust cover.
      Fig 4: Removing Clips And Dust Cover
      G05140348Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Align the matchmarks on the steering intermediate shaft assembly and steering gear assembly.
    4. Remove the bolt and separate the steering intermediate shaft assembly.
      Fig 5: Removing Bolt And Steering Intermediate Shaft Assembly
      G05140349Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  18. REMOVE STEERING COLUMN ASSEMBLY 
    1. Disconnect the connectors and wire harness clamps.
    2. Remove the 3 bolts and steering column assembly from the instrument panel reinforcement assembly.
      Fig 6: Removing Steering Column Assembly
      G05140350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002