Steering Angle Sensor: Installation

INSTALL STEERING SENSOR
1. Install the steering sensor onto the spiral cable.
NOTE:
- Engage the claws securely.
- Be careful not to damage the claws.
Fig 1: Identifying Steering Sensor Claw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD
INSTALL SPIRAL CABLE (See INSPECTION )
CENTER SPIRAL CABLE (See INSPECTION )
INSTALL STEERING COLUMN COVER UPPER (See INSTALLATION )
INSTALL STEERING COLUMN COVER LOWER (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
INSTALL STEERING PAD ASSEMBLY (See INSTALLATION )
INSTALL STEERING WHEEL COVER LOWER NO. 3 (See INSTALLATION )
INSTALL STEERING WHEEL COVER LOWER NO. 2 (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
INSPECT STEERING PAD ASSEMBLY
INSPECT SRS WARNING LIGHT
(See DIAGNOSIS SYSTEM )