VVT Sensor: Installation

INSTALL VVT SENSOR
1. LH bank side VVT sensor:
  1. Apply a light coat of engine oil to the O-ring of the VVT sensor.
  2. Install the VVT sensor with the bolt.
    Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  3. Connect the VVT sensor connector.
  4. Connect the water by-pass hoses No. 4 and No. 5.
    
    Fig 1: Locating VVT Sensor With Bolt
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. RH bank side VVT sensor:
  1. Apply a light coat of engine oil to the O-ring of the VVT sensor.
  2. Install the VVT sensor with the bolt.
    Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  3. Connect the VVT sensor connector.
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
ADD ENGINE COOLANT (See COOLANT )
CHECK FOR ENGINE COOLANT LEAKAGE (See REPLACEMENT )
INSTALL V-BANK COVER
1. Install the V-bank cover with the 2 nuts.
  Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf)